How to Refill a Brother TN-330 or TN-360 Cartridge (Instructions)

Refilling Procedures:

Use a Flathead screwdriver to pop out the large plug found on the side of the side of the cartridge.

IMPORTANT: you must dispose of any original toner in the cartridge as much as possible before refilling. Dispose of toner Properly into a trash can, or use a vacuum with a hose for best results (if possible).Before opening the bottle of toner, turn it upside down and tap it on a table to lossen the toner and allow it to flow freely. Remove the cap and pull the seal off the bottle. attach the funnel cap making to sure it is on tightly. Tilt the funnel cap toward the fill-ing hole and insert into the hole. if the toner stops flowing before the cartridge is full, simple remove the toner, close to cap, trun the baottle upside down and tap it on the table. Once the cartridge is full, seal the hole with the plug by twisting it until is completely seated. Now gently shake the cartridge side to side to distribute the toner


Installing Reset Gear On Starter Cartridges

1- Remove the screws circled in red in the illustration above. Carefully detach the panel from the cartridge.

2- Reset the flag gear by turning it into the correct position. the picture shows the flag gear in the correct position.

3. Screw the panel back into place, and your cartridge is ready.

The Brother TN360 cartridge refill procedure can also be following for refilling the following printers:

Brother - DCP Series
DCP-7030
DCP-7040
DCP-7045N

Brother - HL Printers
HL-2140
HL-2150N
HL-2170W

Brother - MFC MultiFunction Printers
MFC-7320
MFC-7340
MFC-7345DN
MFC-7345N
MFC-7440N
MFC-7840W

YOU CAN GET THE BROTHER TN360 REFILL KIT AT DISCOUNT PRICE HERE